BluBox Integration

NetLink integration with BluB0X provides alerts, measurements, and control capabilities to BluSKY.  Power system alerts, measurements, and system control features are available directly from the BluSKY interface, streamlining system maintenance and maximizing system uptime.

Integration to BluSKY is via PSIA/XML and is supported by BluB0X.

Requirements & Information

BluSKY Version Supported 
BluB0X License Required 
NetLink Boards SupportedNL2, NL4
NetLink Minimum Firmware Version9.18 or above
Integration TypePSIA / XML
Integration LevelFull


Supported Alerts

AC Fault Alert ●
System Fault Alert ●
Fire Alarm Active ●
Power Supply Service Due ●
Insufficient Battery Standby Time ●
Battery Replacement Due ●
M8 Output Voltage Out of Range ●
M8 Output Current Out of Range ●
Enclosure Temperature Out of Range ●
External Temperature (IDF Closet) Out of Range ●
Tamper Switch Alert ●
Device Detect (Connected or disconnected from NetLink) ●
Current Sensor Out of Range ●
Auxiliary Voltage Out of Range ●


Values Reported

AC Input Voltage 
Power Supply Output Voltage
Power Supply Total Output Current 
Battery Voltage
Battery Charge / Discharge Current
M8 Output (Lock) Voltage
M8 Output (Lock) Current
M8 Output (Lock) Cycle Count 
Enclosure Temperature
External Temperature (IDF Closet)
Current Sensor Measurement
Auxiliary Voltage Measurement


Control Features

Control ItemSupported
Start / Schedule Automated Battery Test ●
Power Cycle M8 Output ●
Power Cycle Power Supply Main Output ●
NetLink Control 1 / Control 2 Outputs ●