Mercury Integration

The capability of native NetLink integration is built-into all LP Series controllers or EP series controllers with firmware revision 1.24.1 or higher (EP Series controllers require the NetLInk to have the "M" version firmware installed).

In order to utilize this integration, your Mercury reseller must add the capability to their interface. Contact your Mercury reseller for more information.

M Version firmware for NetLink when used with EP Series controllers can be downloaded here. Note that LP Series controllers can use the standard NetLink firmware.

Supported Alerts

Alert	Supported
AC Fault Alert	●
System Fault Alert	●
Fire Alarm Active	●
Power Supply Service Due	●
Insufficient Battery Standby Time	●
Battery Replacement Due	●
M8 Output Voltage Out of Range	●
M8 Output Current Out of Range	●
Enclosure Temperature Out of Range	●
External Temperature (IDF Closet) Out of Range	●
Tamper Switch Alert	●
Device Detect (Connected or disconnected from NetLink)	●
Current Sensor Out of Range	●
Auxiliary Voltage Out of Range	●

Values Reported

Value	Supported
AC Input Voltage
Power Supply Output Voltage
Power Supply Total Output Current
Battery Voltage
Battery Charge / Discharge Current
M8 Output (Lock) Voltage
M8 Output (Lock) Current
M8 Output (Lock) Cycle Count
Enclosure Temperature
External Temperature (IDF Closet)
Current Sensor Measurement
Auxiliary Voltage Measuremen

Control Features

Control Item	Supported
Start / Schedule Automated Battery Test	●
Power Cycle M8 Output	●
Power Cycle Power Supply Main Output	●
NetLink Control 1 / Control 2 Outputs	●